CÔNG TY TNHH ĐẦU TƯ VÀ PHÁT TRIỂN THƯƠNG MẠI VIỆT HƯNG

Địa chỉ: Số nhà số 36 phố Định Công Thượng, Phường Định Công, Quận Hoàng Mai, Hà Nội, Việt Nam. VP đại diện: P704, Tòa nhà Hoàng Sâm, Đường Hoàng Sâm, Cầu Giấy, Hà Nội. ĐT: 04.62694321 – Fax: 04.62694320

Card chuyển đổi PCI to PC/104

Chi tiết

Thông tin sản phẩm:

 

\"\"

This passive extender card allows developers to install a PCI-104 or PC/104-Plus serial card into a Universal PCI bus system. The adapter is equipped with a stack-through connector so the test card can be installed on either side (model AD001), enabling probing on the front or the back. The design also allows cables to exit from the host PC for easy connection to external devices.

Specifications

  • Compatible with standard Universal, 3.3V or 5V PCI slot

  • Industrial temperature operating range (-40°C to 85°C)

  • Connectors/Interfaces include a PCI-104 120 pin stack-through connector with shroud for connection to the host CPU board and PC/104 64 and 40 pin passive stack-through connectors (model AD001)

  • Measures 4.913" wide by 4.200" high

  •  

    Special  Usage 
    You may have a situation in which you cannot set the test card to ID0, the default configuration of the PCI to PC/104-Plus adapter. In this rare case, you will need the following information to configure the adapter to apply to your particular setup. 

    REQ, GNT, CLK and IDSEL selection
    To ensure each card within a PC/104-Plus stack has a unique set of signals (REQx, GNTx, CLKx and IDSELx) multiple copies of these signals exist in the PC/104-Plus bus, numbered 0 to 3. The REQ, GNT, CLK and IDSEL jumper blocks will route the PCI signal to the equivalent PC/104-Plus signal. If your test card is configured to use a different ID, then you need to move the resistors on the adapter to coincide with that ID. If your PC/104 card is set to ID3, for example, move the resistors in the REQ, GNT, CLK and IDSEL locations on the face of the card to the row numbered 3 to connect the signals to your test card. 

    Interrupt selection
    The default configuration is sufficient in most cases and routes the PCI INTA, B, C and D interrupt lines to the INTA, B, C and D lines on the PC/104-Plus card. If need be, you can select which PCI interrupts are routed to the PCI-104 or PC/104-Plus interrupt lines via the INTx blocks. To change the default selection, jumper the corresponding PCI interrupts to route to the INTA, B, C and D signals on the PC/104-Plus connector. For example, jumper the adapter’s INTA C position to route INTA to the PC/104-Pluscard’s INTC. (It is recommended you route unique interrupts to each of the PC/104-Plus interrupt lines.)

     



Tình trạng kho: Hết - Call

Sản phẩm cùng loại